Wika Pascal 100 Manual de usuario descargar pdf (Pagina 68)

6 Commissioning, operation

68 WIKA Operating Instruction, Pascal 100 and Pascal 100/IS

Press SETUP to set the ramp:

Figure 76 – Ramp parameters setup

Here above a ramp has been set: starting from 0 V, in 11 steps it reaches 1 V after 20 sec.: then it

remains standstill for 5 sec. The ramp will be executed 2 times (Cycles num.).

Press OUT A to start the ramp function: the instrument will show the main screen and the writing

RMP will be displayed to show that the function ramp is active.

Figure 77 - Ramp running

If another channel is assigned to OUT B, here below you can see how the Ramp will be shown:

Figure 78 – Ramp setup with both OUTs

OUT A & B are both available. The Ramp can start for both the channels simultaneously

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 92 93

Sin comentarios

Wika Pascal 100 Manual de usuario Pagina 68