Wika CPH6300 Manual de usuario descargar pdf (Pagina 21)

6 Commissioning, Operation

WIKA Operating Instruction, Model CPH6300 21

14043054.01 07/2012 GB/D

6.5 Data Logger

The device supports two different logger functions:

“Func-Stor”: Manual recording by keypress “store“

Additional input of measuring point (L-Id) is needed

“Func-CYCL”: Automatic recording at intervals of set cycle time

1-channel version:

The logger stores 3 measuring values per data set:

■ “CALC off”: measuring or average (depends on function), min-peak and max-peak

■ “CALC active”

: measuring or average (depends on function), Calculated value and dummy

value

2-channel version:

The logger stores 9 measuring values per data set:

■ measuring or average (depends on function), min-peak and max-peak sensor 1

■ measuring or average (depends on function), min-peak and max-peak sensor 2

■ measuring or average (depends on function),

■ “CALC off”: min-peak and max-peak sensor 1 – sensor 2

■ “CALC active”

: Calculated value and dummy value

Min- and max-peak are the minimum and the maximum of the measured values since the last

recording.

This allows precise analysis of the current pressure as well as pressure fluctuations.

For the evaluation of the data the software GSOFT (version V3.0 or higher) has to be used. The

software also allows easy configuration and starting of the logger. (Free updates are available on

our website www.wika.de

)

When the logger is activated (Func Stor or Func CYCL) the hold function is no more available, the

key “STORE” is solely used for the operation of the logger functions.

6.5.1 Manual Recording (“Func-Stor”)

a) Save measurements manually:

Up to 1000 measurements can be saved if logger function “Func store” is selected

(see “Configuration”):

Press shortly: data set is saved (“St. XX” is displayed shortly,

where XX is the number of the data set)

Input of measuring point “L-Id”: Selection of measuring point via keys or .

Number 0 … 19999 or text assigned to number 1 … 40

Assignment of texts can be done with free software “ConfigSoft” which can be

downloaded on our website www.wika.com

Confirm input with .

CALC-Function: see chapter 6.4.5

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Comentarios a estos manuales

Sin comentarios

Wika CPH6300 Manual de usuario Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Wika CPH6300