Wika Pascal ET Manual de usuario Pagina 18
- Pagina / 88
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
6 Commissioning, operation
18 WIKA Operating Instruction, Pascal ET and Pascal ET/IS
GB
6.1.2.1 Input module for electrical/temperature signals
The input module for electrical/temperature parameters measurement is one of those modules
inserted from the instrument’s front panel; two slides drive the module into its position. It is possible
to have up to two input modules in the same instrument: IN A and IN B. This terminology is used
also by the software to carry out the connection between physical input IN and software channel.
For example: if you connect a thermoresistance Pt100 to module IN A, the temperature measured
by this thermoresistance can be displayed in any of the four software channels available. The
following figure shows the pins connection in electrical/temperature IN module.
Figure 1 – Input panel module
6.1.2.2 Output module for electrical/temperature signals
The output module for electrical/temperature parameters generation or simulation is one of those
inserted from the instrument’s front panel; two slides drive the module into its position. It is possible
to have up to two output modules in the same instrument: OUT A and OUT B. This terminology is
used also by the software to carry out the connection between physical output OUT and software
channel. For example: if you connect a signal-receiver to module output OUT A, the current 4…20
mA generated can be displayed in any of the four software channels available.
The following figure shows the output module for electrical/temperature parameters.
Figure 2 – Output panel module
The 2 INPUT cards and 2 OUTPUT cards are plug and play modules and can be installed by the
user himself.
- Operating instructions 1
- 1 General Information 5
- 2 Safety 6
- below 7
- ■ Battery operation: 8
- ■ Ex Hazardous Areas 8
- 3 Specifications 11
- 3 Specifications 13
- 4 Design and Function 14
- 6 Commissioning, operation 17
- HART slave 20
- Transmitter 21
- Figure 20 – Range setup 34
- Figure 49 – mA range setup 47
- Figure 69 – Realtime graph 64
- Figure 70 – Ramp profile 65
- Figure 71 – RAMP Menu 65
- Figure 73 - Ramp running 66
- Figure 75 – DISK Menu 67
- Figure 76 – Main screen 67
- – Offset Off 70
- Figure 85 – Report menu 72
- Figure 86 – Report setup 73
- Figure 96 – Menu Logger 77
- Figure 98 – Logger running 78
- Figure 99 – Display Log list 78
- Appendix 83
Relacionado con productos y manuales para Instrumentos de medición Wika Pascal ET
(90 paginas)
Instrumentos de medición Wika CAL Manual de usuario
(136 paginas)
(136 paginas)
Instrumentos de medición Wika BCS10 Manual de usuario
(108 paginas)
(108 paginas)
Philips DLM52526/10 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Ladegeräte Philips DLM52526/10.
Wir stellen 1 PDF-Handbücher Philips DLM52526/10 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Datenblatt
Comentarios a estos manuales