Wika Pascal ET Manual de usuario descargar pdf (Pagina 66)

6 Commissioning, operation

66 WIKA Operating Instruction, Pascal ET and Pascal ET/IS

Press SETUP to set the ramp:

Figure 72 – Ramp parameters setup

Here above a ramp has been set: starting from 0 V, in 11 steps it reaches 1 V after 20 sec.: then it

remains standstill for 5 sec. The ramp will be executed 2 times (Cycles num.).

Press OUT A to start the ramp function: the instrument will show the main screen and the writing

RMP will be displayed to show that the function ramp is active.

Figure 73 - Ramp running

If another channel is assigned to OUT B, here below you can see how the Ramp will be shown:

Figure 74 – Ramp setup with both OUTs

OUT A & B are both available. The Ramp can start for both the channels simultaneously

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 87 88

Sin comentarios

Wika Pascal ET Manual de usuario Pagina 66