Wika CPH7600 Manual de usuario descargar pdf (Pagina 42)

42 WIKA operating instructions, model CPH7600

14051628.01 11/2012 GB/D

8. Faults

Display Reason Measures

Low battery power, device will

only work for a short while longer

Replace battery

-OL

Well above or below the limits of

the measuring range

Check: is the pressure within the

permissible measuring range of

the sensor?

--> Reduce the applied pressure

No display or

strange symbols,

device is not

responding to

input

Battery at Replace battery

System error Switch o the instrument, wait

for a short period of time, switch

on again

Technical fault Return to manufacturer for repair

CAUTION!

If faults cannot be eliminated by means of the measures listed above,

the hand held pressure calibrator must be shut down immediately, and it

must be ensured that pressure and/or signal are no longer present, and it

must be prevented from being inadvertently put back into service.

In this case, contact the manufacturer.

If a return is needed, please follow the instructions given in chapter

9.2 "Return".

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 91 92

Sin comentarios

Wika CPH7600 Manual de usuario Pagina 42