Wika TR10-J Manual de usuario descargar pdf (Pagina 5)

WIKA operating instructions resistance thermometers, thermocouples

11208287.06 10/2013 GB/D/F/E

2. Safety

WARNING!

Before installation, commissioning and operation, ensure that the appropriate

thermometer has been selected in terms of measuring range, design and specic

measuring conditions.

Choose the thermowell with regard to the maximum pressure and temperature (e.g.

table of contact ratings in DIN 43772).

Non-observance can result in serious injury and/or damage to equipment.

Further important safety instructions can be found in the individual chapters of these

operating instructions.

2.1 Intended use

These resistance thermometers and thermocouples are used for temperature measurement in

industrial applications.

The instrument has been designed and built solely for the intended use described here, and may

only be used accordingly.

The technical specications contained in these operating instructions must be observed. Improper

handling or operation of the instrument outside of its technical specications requires the

instrument to be shut down immediately and inspected by an authorised WIKA service engineer.

If the instrument is transported from a cold into a warm environment, the formation of

condensation may result in the instrument malfunctioning. Before putting it back into operation,

wait for the instrument temperature and the room temperature to equalise.

The manufacturer shall not be liable for claims of any type based on operation contrary to the

intended use.

2.2 Personnel qualication

WARNING!

Risk of injury should qualication be insucient!

Improper handling can result in considerable injury and damage to equipment.

■

The activities described in these operating instructions may only be carried out by

skilled personnel who have the qualications described below.

■

Keep unqualied personnel away from hazardous areas.

Skilled personnel

Skilled personnel are understood to be personnel who, based on their technical training,

knowledge of measurement and control technology and on their experience and knowledge of

country-specic regulations, current standards and directives, are capable of carrying out the

work described and independently recognising potential hazards.

Special operating conditions require further appropriate knowledge, e.g. of aggressive media.

2. Safety

1 2 3 4 5 6 7 8 9 10 ... 67 68

Sin comentarios

Wika TR10-J Manual de usuario Pagina 5