Wika TIF52 Manual de usuario descargar pdf (Pagina 31)

WIKA operating instructions models TIF50, TIF52

14009686.02 03/2012 GB/D

The following table shows the error codes and information regarding the failure cause and

elimination.

Error code Description Causes

Transmitter does not respond

2 Communication error

■

Parity, check sum, package length incorrect upon

receiving

■

Transmitter signals receive error

3 Command not implemented Command not supported by the transmitter

4 Range error

■

The value is outside the range supported by the

sensor

■

The desired unit of measure is not supported

5 Unspecied error of the

transmitter

The sensor signals an error in the status byte that is

not broken down

CAUTION!

If faults cannot be eliminated by means of the measures listed above, the

instrument must be shut down immediately, and it must be ensured that signal

is no longer present, and it must be prevented from being inadvertently put back

into service. In this case, contact the manufacturer.

If a return is needed, follow the instructions given in chapter 12.1 "Return".

12. Dismounting, return and disposal

WARNING!

Residual media in the dismounted instrument can result in a risk to persons, the

environment and equipment. Take sucient precautionary measures.

12.1 Return

WARNING!

Absolutely observe the following when shipping the instrument:

All instruments delivered to WIKA must be free from any kind of hazardous

substances (acids, leachate, solutions, etc.).

When returning the instrument, use the original packaging or a suitable transport package.

11. Faults / 12. Dismounting, return and disposal

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 67 68

Sin comentarios

Wika TIF52 Manual de usuario Pagina 31