Wika CPG2500 Manual de usuario descargar pdf (Pagina 58)

58 Mensor/WIKA Operating Instructions Series CPG 2500

Digital Pressure Gauge

SERIES CPG 2500

7.1.3.8.4 General SCPI WIKA Commands

STATus

:OPERation

:CONDition? Returns an integer value representing instru-

ment status that can be decoded.

Bit 0: Zeroing active.

Bit 1: Control Setpoint has not been reached.

Bit 2: Reserved 0.

Bit 3: Reserved 0.

Bit 4: Measuring. The instrument is actively

measuring.

MEASure

[:PRESsure] [z]? Returns the pressure in the current units from

the specified sensor, or active sensor if [z] is

omitted.

:TEMPerature[z]? Returns the temperature in deg. C. from the

specified sensor, or active sensor if [z] is omit-

ted.

:RATE[z]? Returns the pressure rate in the current units

from the specified sensor, or active sensor if [z]

is omitted.

:BAROmetric? Returns the barometric pressure in the current

unit, if a barometer sensor is installed.

CALibration

:MODE? Returns 1 if the sensor has been calibrated or 0

if not.

:DATE? Returns the stored calibration date.

:DATE <i,i,i> Sets the calibration date (YYYY,MM,DD).

:ZERO? Returns current zero point correction in bar.

:ZERO <n> Sets the zero so the currently measured

pressure matches the commanded value in the

current unit. Limited to +/-5% FS.

ZERO:RUN Vents the instrument and sets zero so the

currently measured pressure = 0.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 87 88

Sin comentarios

Wika CPG2500 Manual de usuario Pagina 58